DRONE ART 88025RC, Руководство по эксплуатации

Страница: 19 / 28

Video Channel Selection - Automatic | 19
21. Video channel selection - Automatic
Your Xtreme V2 comes out of the box already bound to the transmitter. Once transmitter
and Xtreme V2 are powered on and you do not see the live feed image on the transmitter
screen after a few seconds start the auto channel scan.
Hold down the
SCAN button on the transmitter for a short moment then release it. The
video receiver system will automatically scan and find the current band and channel that
your Xtreme V2 is on and bind.
Important note: sometimes Auto channel scan will connect to a
neighboring band/channel. This can limit video range and reception.
If you experience either of these limitations please refer to chapter ‘22.
Video channel selection - Manual’ on page 19.
22. Video channel selection - Manual
To manually change the channel/band proceed as described in the following chapters.
22.1 Xtreme V2
1. Turn Xtreme V2 and transmitter off.
2. Remove the video transmitter hatch to get access to the manual channel button. Also
refer to chapter ‘13. Basic control’ on page 13 .
3. Turn Xtreme V2 and transmitter on.
4. Quickly press the button. The current band and channel will be displayed in the top
right corner of the transmitter screen.
5. Hold down the button for about 1.5 seconds until the channel flashes on the screen.
6. Repeatedly press the button to cycle through the available channels/bands until the
frequency you wish to use is displayed. The channel/band is automatically saved when
you stop cycling. Allow a short amount of time for the saving procedure to complete.
22.2 Transmitter
1. Press the scan button SCAN to display the current channel/band.
2. Press the + button on the transmitter to change the frequency band. Press the – button
to change the video channel. Cycle until you find the frequency you wish to use.
3. The channel/band is automatically saved when you stop cycling. Allow a short amount
of time for the saving procedure to complete.
23. Preflight checklist
Before turning on the transmitter and Xtreme V2, please run through below checklist:
■
Are the propellers installed in correct orientation?
■
Are the propellers secured and undamaged?
■
Are the batteries in good condition and fully charged?
■
Is the flight battery properly secured?
■
Is the battery door properly closed?
■
Is a microSD card installed (in case of using on board recording)?