DRONE ART 88025RC, Руководство по эксплуатации

Страница: 17 / 28

Altitude Hold | 17
16. Altitude hold
Only available for Beginner and Sport modes
■
Pressing the ALT-Hold button toggles the altitude hold function on/off.
ALT-hold
F-mode
■
If Alt-Hold is activated, the colour of the LEDs on the front arms alternatingly change
between orange and the flight mode color every second.
Above illustrated example:
Green front LEDs designates beginner mode. When Alt-hold is activated, the front LEDs
change every second as follows:
Orange > Green > Orange > Green
17. Binding the transmitter
Transmitter and receiver are bound during production. In case it becomes necessary to
rebind transmitter and receiver follow the following steps:
1. Remove the propellers for safety reasons.
2. Power on the Xtreme V2, leave the transmitter turned off.
3. Wait approx. 10 seconds and on the side of your Xtreme V2 you will see a little orange
LED light flashing on one of the side holes. This means the Xtreme V2 is in bind mode.
4. Hold down the ALT-Hold button on the transmitter while turning on the transmitter by
pressing the power button on the radio.
5. Release the ALT-Hold button once powered on. Wait a few moments.
6. The orange LED on the Xtreme V2 should make a few flashes and go solid.
7. Binding is complete.
8. Install the propellers again.
18. Emergency auto level
In expert mode (auto level disengaged) you have an emegergency auto levelling feature
available.
If at any time during practicing in this mode you lose orientation or control over your Xtreme
V2 you can engage the auto level feature to assist you in regaining control.
To engage the auto level feature in flight in expert mode, hold down the flight mode button
F-mode on the transmitter for more than 0.5 s. Auto level remains enganged as long as you
hold down the flight mode button. Release the flight mode button to disengage auto level.