Drive DeVilbiss Healthcare 9003, Инструкция по эксплуатации

Страница: 19 / 24

Braking
Position the brake pedal in the ‘brake’ position (see section 8 for brake operation).
Now try to move the cot with a normal level of force. Should any of the three braked
castors rotate/move, the brake system is not working effectively.
Position the ‘brake’ pedal in the ‘steer’ position and check that the steering lock is
operating efficiently.
If you experience difficulty or lack of effectiveness with either the braking or steering
contact your authorised service personnel or contact Drive DeVilbiss Healthcare.
Batteries
When the cot is being used via the battery backup facility the control box will sound
an audible alarm when a low charge situation is reached. A minimum of 24 hours
charging time should be allowed to fully recharge the batteries.
Drive DeVilbiss Healthcare recommends checking the condition of the batteries every
six months.
19
18. SPECIFICATION
Overall length 1450mm
Overall width 820mm
Height range (to top of mattress platform) 585mm to 920mm
Mattress platform tilt (forward and reverse) 0-12°
Safe working load - When not in tilt
- When in tilt
Maximum patient weight - When not in tilt
Maximum patient weight - When in tilt 160kg (25 stone)
50kg (8 stone)
140kg (22 stone)
45kg (7 stone)
Voltage in: 230V
±
10%, ~50/60Hz.
Current in: 2A
Mains cable fuse: 3-10A
Mains plug: Type G/BS1363
*Duty
cycle: 10%
2 mins of continuous use followed by 18 mins not
in use.
18.1 Electrical Data
*Electrically operated cots are intended to be operated intermittently rather than continuously. If the cot is operated
continuously for up to 2 minutes it must then be left for at least 18 minutes before re-use to allow the electrical system to
cool sufficiently. If the cot is continuously used for an extended period of time and it exceeds the duty cycle the control box
may become temporarily disabled or irreparably damaged.