Installing Your 100 Series
Installing Your 100 Series
2-26
Flushing Your Filters
Certain types of filters require flushing prior to use. T
his is important for both the filters
lifespan, and the long term lifespan of your 100 Series. Additionally, replacements
for these types of filters should be flushed each time one is replaced, prior to
installing.
For your kit, the two specific filters that need flushed are
F2
Chemical Scrub
and
F4
Polishing Scrub
.
This section will require
A
,
the filters listed above, scissors, and a container to flush water into (if your sink isn’t within
reach of your water line).
1. Begin by cutting a 3 ft. to 5 ft. section of
Make sure to
cut the tubing at a 90 degree (perpendicular) angle.
Diagram 2.5.1
Cut Tubing Perpendicularly
2. Next, insert one end to the labeled
IN port
.
Be
sure to forcefully push tubing all the way into the QC input until it won’t insert any further.
