Drinkpod 100 Series, Руководство по установке

Страница: 39 / 64

Installing Your 100 Series
Installing Your 100 Series
2-37
Diagram 2.6.3-A - Screw Compression To Quick Connect Adapter Onto Port or Hose
acc.
1x
For 1 Accessory Appliance Configurations , you will need to run a section of
A
1/4 in. White PP Tubing from your Accessory Appliance, directly to where
you plan to locate your 100 Series (unless the appliance already has an integrated
Quick Connect Tubing hose you plan to use instead). Finish by connecting the
other
C
1/4 in. Quick Connect Shutoff Valve to the end of the tubing or hose
that will connect to your 100 Series. It should look like this:
acc.
1x
HOSE/PORT > ADAPTER (if necessary) > TUBING (if necessary) >
SHUTOFF VALVE (where 100 Series will be located)
Once you’ve completed this, jump ahead to
“Connecting 100 Series” on page 2-43 .
If your Accessory Appliance’s port or hose is
Female Compression
, use
D
1/4 in. Brass Compression Union to adapt the port/hose to the
1/4 in. White PP Tubing line (referenced above). Instructions for this are including in
the following step and “Diagram 2.6.4-B” on page 2-39 .
Extending
If your appliance has a port (rather than a hose), or a hose that will not reach sufficiently
far, follow the relevant directions below.
To extend Quick Connect Tubing , use
D
1/4 in. Brass Compression Union