© DreamLine
All Rights Reserved
© DreamLine
All Rights Reserved
16
UNIDOOR-X (STYLE M) manual Ver 2 Rev 1 02/2019
©2019 DreamLine. All Rights Reserved
Fig 12
inside
wall
1
4
inside
wall
5
inside
wall
0
1/8”
3
(or Ø5/16"
& anchor
for tile)
inside
wall
2
Install the bottom U-channel
parallel to the outside edge
of the threshold and at the
correct dimension based on the
model configuration
!
NOTE:
Refer to the enclosure panel
manual for the correct dimension for
an enclosure installation
!
NOTE: If installing this hinge panel and door for
one of the Unidoor-X enclosure configurations,
it is important that the hinge panel is installed at
the correct dimension for the enclosure model
size. Refer to the panel installation manual
packaged with the panel glass for details and
dimensions.
12.
Position the
U-channel 2 (bottom profile) (#29)
onto the threshold, parallel to the outside edge. Mark
the position of the U-channel and mark the position of
the holes for drilling. You need to use at least 3 holes
for the
U-channel 2 (bottom profile) (#29)
: one near
each end and one near the center.
• Drill the holes into the threshold using an
Ø1/8”
drill
bit. (Or use a
Ø5/16”
bit and anchor for tile)
• Apply a bead of silicone to the bottom of the
U-channel 2 (bottom profile) (#29)
and attach it to
the threshold using the
ST4.2 x 40mm Countersunk
Screws
(#23). (Fig 12)
