http://dreamcatcher.asia/cw
______________________________________________________________________
ME3000 Analog Electronics
Lab 6 - 9/19
2. Make the connection as shown in
Figure
B-2 in order to measure DC voltage. You can
control the U2741A via the
Agilent
Measurement Manager (AMM)
software for U2741A or
via
SCPI commands
sent through the USB interface from your own application programs.
Figure B-2 – Measuring DC Voltage
3. If you are using the
AMM
, select the
DCV
function located at the top-left corner. Set the
desired range under
Range
section. A suitable range should be selected to give the best
measurement resolution. The reading is displayed and updated continuously.
4. If you are using
SCPI commands
, enter
MEASure[:VOLTage]:DC?
in order to make a DC
voltage measurement.
Measuring DC Current
1. The DC current measurement function of the U2741A has the following features:
three ranges to select:
10 mA
,
100 mA,
1 A
, and
2 A
; or
auto
range
input impedance is
10 MΩ
for all ranges (typical)
input protection fuse is
2 A,
voltage rating
250 V
on all ranges
2. Make the connection as shown in
Figure
in order to measure DC current. You can control
the U2741A via the
Agilent
Measurement Manager (AMM)
software for U2741A or via
SCPI
commands
sent through the USB interface from your own application programs.
Figure B-3 – Measuring DC Current
3. If you are using the
AMM
, select the
DCI
function located at the top-left corner. Set the
desired range under the
Range
section. A suitable range should be selected to give the best
measurement resolution. The reading is displayed and updated continuously.
4. If you are using
SCPI commands
, enter
MEASure:CURRent[:DC]?
in order to make a DC
current measurement.
