6
DRAWMER
INSTALLATION
The MC7.1 is a free standing, desktop unit, with controls and headphone jacks on
the front panel and all other inputs and outputs on the rear.
Screwing the MC7.1 to a desk.
Rather than having the MC7.1 free standing it can be fastened down to a desk by
utilising the holes that hold the rubber feet to the underside. Note that when fixing
to a desk the speaker trims on the base of the unit will not be accessible and so the
calibration procedure should be carried out before fastening the MC7.1 in place
(see ‘Monitor Calibration’).
Drill four holes into the desk, at
4mm in diameter and to the
dimensions as shown in the
diagram. (Note that in the
diagram the MC7.1 is viewed
from above).
Pushing four screws through the
underside of the desk screw the
MC7.1, including the rubber feet,
to the panel to secure. The
screws should be M3 and have a
length of 14mm plus the
thickness of the panel.
Input Channels
20
Output Channels
15
(+8 through)
Analog Inputs
1 x DB-25 (Surround A),
8 x 1/4" Jack (Surround B),
2 x XLR/Jack Combi (Stereo),
1 x 1/8” Stereo Jack (Aux.)
Analog Outputs
8 x 1/4" Jack (Surround Monitors),
2 x 1/4" Jack (Stereo Monitors),
1 x 1/4" Jack (Sub/Mono Monitor),
1 x DB-25 (through output),
2 x 1/4" Stereo Jack (Headphones)
Talkback
Yes (with internal & external mic, and footswitch)
Form Factor
Desktop wedge
Dimensions
220mm (depth) x 275mm (width) x 100mm (height)
