background image

3

MC7.1

 - Surround Monitor Controller

COPYRIGHT

This manual is copyrighted © 2017 by Drawmer Electronics Ltd. With all rights reserved. Under copyright
laws, no part of this publication may be reproduced, transmitted, stored in a retrieval system or translated
into any language in any form by any means, mechanical, optical, electronic, recording, or otherwise,
without the written permission of Drawmer Electronics Ltd.

Drawmer Electronics Ltd., warrants the Drawmer 

MC7.1 Surround

Monitor Controller 

to conform substantially to the specifications of

this manual for a period of one year from the original date of purchase

when used in accordance with the specifications detailed in this

manual. In the case of a valid warranty claim, your sole and exclusive

remedy and Drawmer’s entire liability under any theory of liability will

be to, at Drawmer’s discretion, repair or replace the product without

charge, or, if not possible, to refund the purchase price to you. This

warranty is not transferable. It applies only to the original purchaser

of the product.

For warranty service please call your local Drawmer dealer.

Alternatively call Drawmer Electronics Ltd. at +44 (0)1709 527574.

Then ship the defective product, with transportation and insurance

charges pre-paid, to Drawmer Electronics Ltd., Coleman Street,

Parkgate, Rotherham, S62 6EL UK. Write the RA number in large

letters in a prominent position on the shipping box. Enclose your

name, address, telephone number, copy of the original sales invoice

and a detailed description of the problem. Drawmer will not accept

responsibility for loss or damage during transit.

This warranty is void if the product has been damaged by misuse,

modification, unauthorised repair or installed with other equipment

that proved to be faulty.

THIS WARRANTY IS IN LIEU OF ALL WARRANTIES, WHETHER

ORAL OR WRITTEN, EXPRESSED, IMPLIED OR STATUTORY.

DRAW MER  MAKES NO OTHER W ARRANTY EITHER

EXPRESS OR IMPLIED, INCLUDING, WITHOUT LIMITATION,

ANY IMPLIED WARRANTIES OF MERCHANTABILITY, FITNESS

FOR A PARTICULAR PURPOSE, OR NON-INFRINGEMENT.

PURCHASER’S SOLE AND EXCLUSIVE REMEDY UNDER THIS

WARRANTY SHALL BE REPAIR OR REPLACEMENT AS

SPECIFIED HEREIN.

IN NO EVENT WILL DRAWMER ELECTRONICS LTD. BE LIABLE

FOR ANY DIRECT, INDIRECT, SPECIAL, INCIDENTAL OR

CONSEQUENTIAL DAMAGES RESULTING FROM ANY

DEFECT IN THE PRODUCT, INCLUDING LOST PROFITS,

DAMAGE TO PROPERTY, AND, TO THE EXTENT PERMITTED

BY LAW, DAMAGE FOR PERSONAL INJURY, EVEN IF

DRAWMER HAS BEEN ADVISED OF THE POSSIBILITY OF

SUCH DAMAGES.

Some states and specific countries do not allow the exclusion of

implied warranties or limitations on how long an implied warranty may

last, so the above limitations may not apply to you. This warranty gives

you specific legal rights. You may have additional rights that vary from

state to state, and country to country.

For the USA

FEDERAL COMMUNICATIONS COMMISSION RADIO

FREQUENCY INTERFERENCE STATEMENT

This equipment has been tested and found to comply with the limits

for a Class B digital device, pursuant to Part 15 of the FCC Rules.

These limits are designed to provide reasonable protection against

harmful interference in a residential installation. This equipment

generates, uses and can radiate radio frequency energy and, if not

installed and used in accordance with the instructions, may cause

harmful interference to radio communications. However, there is no

guarantee that interference will not occur in a particular installation.
If this equipment does cause interference to radio or television

reception, which can be determined by turning the equipment off an

on, then the user is encouraged to try to correct the interference by

one or more of the following measures:

Re-orient or relocate the receiving antenna.

Increase the separation between the equipment and  the receiver.

Connect the equipment into an outlet on a circuit  different from that

to which the receiver is connected.

Consult the dealer or an experienced radio/TV technician for help.

Unauthorised changes or modification to this system can void the

users’ authority to operate this equipment.

This equipment requires shielded interface cables in order to meet

FCC class B limit.

For Canada

CLASS B                                    NOTICE

This digital apparatus does not exceed the Class B limits for radio
noise emissions set out in the Radio Interference Regulations of the

Canadian Department of Communications.

CLASSE B                                    AVIS

Cet appareil numérique ne dépasse pas les limites de la classe B au

niveau des émissions de bruits radioélectriques fixés dans le

Règlement des signaux parasites par le ministère Canadien des

Communications.

In the interests of product development, Drawmer reserve the right to modify

or improve specifications of this product at any time, without prior notice.

SAFETY CONSIDERATIONS

CAUTION - SERVICING

DO NOT OPEN. REFER ALL SERVICING TO QUALIFIED SERVICE PERSONNEL.

WARNING

TO REDUCE RISK OF FIRE/ELECTRIC SHOCK DO NOT EXPOSE THIS EQUIPMENT TO MOISTURE.

WARNING

DO NOT ATTEMPT TO CHANGE OR TAMPER WITH THE SUPPLIED POWER SUPPLY OR CABLES.

WARNING

THERE ARE NO USER REPLACEABLE FUSES W ITHIN EITHER THE MC7.1 OR IT’S SUPPLIED

POWER SUPPLY. IF FOR ANY REASON THE MC7.1 CEASES TO WORK DO NOT ATTEMPT TO

MEND IT - CONTACT DRAWMER TO ARRANGE FOR A REPAIR/REPLACEMENT.

WARNING

DO NOT PLUG IN THE EXTERNAL POW ER SUPPLY W HILST THE POW ER SWITCH ON THE REAR

OF THE MC7.1 IS IN THE ON POSITION.

ONE YEAR LIMITED WARRANTY

Содержание MC7.1





























Отзывы: