- 13 -
- 12 -
8. INSTALLATION AND ASSEMBLY
8. INSTALLATION AND ASSEMBLY
8.3 MAIN BODY
Using an engine crane or other suitable lifting equipment and
load slings to remove main body from pallet after unbolting it
from the pallet.
8.5 ASSEMBLY AND ATTACHMENT OF
PNEUMATIC COLUMN STEPS 1 TO 8.
1. Lift the column into place.
WARNING:
Pneumatic column is heavy and requires two people to
position and fit safely.
8.4 INSTALL MAIN BODY.
Using floor bolts/anchors fix the main body to
the floor. The floor must be smooth and level
concrete, able to support the weight of the
machine. Main body must be bolted down
BEFORE assembly!
Note: If the machine is not bolted to the floor,
this will invalidate your warranty.
WARNING:
Failure to correctly bolt the machine
to the floor will cause personal injury or death.
Correct installation is critical to the safe use of
this machine.
1
4
2
5
7
8
6
3
Connect the pneumatic ramp to the column
with nut and bolt and washer supplied.
Align the spindle holes, then carefully tap with a
soft face hammer to insert the pivot pin.
Connect the pneumatic column air pipe.
Fit column base cover.
Tilt pneumatic column backwards and hold in place while you insert head and then secure the
compression spring with cap and hex. head screw.
