- 14 -
- 11 -
8. INSTALLATION AND ASSEMBLY
8. INSTALLATION AND ASSEMBLY
8.2 ASSEMBLY
This equipment is supplied on a wooden pallet.
First remove the pneumatic column unit from the pallet.
WARNING:
This unit is heavy and requires careful
handling.
2
8.6 ASSEMBLY AND ATTACHMENT OF ASSIST ARM — STEPS 1—5
The assist arm is supplied in it’s own pallet, it will need to be attached to the main body and
assembled.
8.1 DETERMINE THE PROPER LOCATION
FOR THE TYRE CHANGER.
Warning!
Make sure this machine is used indoors on a dry,
oil/grease free, flat, level CONCRETE surface capable of
supporting the weight of the tyre changer and any additional
tools, equipment and tyre/ wheel combinations.
For safe and ergonomic use of the machine it is advisable to
locate the machine a minimum of 500mm from the side walls
and 1000mm from back wall.
– The tyre changer is designed for indoors use only. Do not
install or use outdoors, or in damp or wet locations away
from the risk of any liquid.
– Make sure to check the desired location for possible
obstructions such as a low ceiling, overhead lines,
adequate working area, access ways, exits, etc.
– The tyre changer MUST be located in an area free of
flammable materials and liquids.
1000mm
500mm
1
2
3
4
5
IMPORTANT
BEFORE YOU START YOU WILL NEED THE FOLLOWING ITEMS.
Engine crane, load slings, (drill and drill bits suitable for drilling into a
concrete floor), floor bolts.
WARNING:
Do not attempt to install this on your own! Minimum 2 person job.
Screw the support leg into the base of the
assist arm.
Attach the top arm with control switch.
Insert pivot pin.
Insert arm into bracket .
Using an engine crane position and bolt the
assist arm column to the main body with 3 bolts
supplied (2 at side, 1 from the back) and adjust
the support leg C to meet the floor.
B
A
C
