- 8 -
- 17 -
5. HEALTH AND SAFETY INFORMATION
8. INSTALLATION AND ASSEMBLY
5.2 SPECIFIC SAFETY INSTRUCTIONS FOR TYRE CHANGER USE
• Make sure this machine is used on a dry, flat, level, oil/grease free, concrete surface capable of
supporting the weight of the tyre changer, any additional tools, equipment and wheel tyre
combination.
• Before each use, always examine the tyre changer for structural cracks and bends, damage to
the safety guard, electrical wiring, and any other condition that may affect the safe operation of
the machine. Do not use the tyre changer even if minor damage is apparent.
• Maintain a safe working environment. Keep the work area well lit. Make sure there is adequate
surrounding workspace. Always keep the work area free of obstructions, grease, oil, and other
debris. Do not use the tyre changer in a damp or wet location. Do not use the tyre changer in
areas near flammable chemicals, dusts, and vapours.
• This tyre changer is designed for use with most passenger car and light commercial vehicle
wheels. Do not attempt to exceed this machine’s maximum wheel diameter capacity.
• Always keep hands, fingers, and feet away from the moving parts of the tyre changer while the
machine is in use.
• Never leave the tyre changer unattended when it is running. After completing a tyre changer
job, always turn the Power Switch to its “OFF” position, and wait until the machine comes to a
complete stop before leaving.
• Make sure you read and understand all instructions and safety precautions as outlined in the
manufacturer’s manual for the wheel you are balancing, and the vehicle the wheel is to be used
on.
• Always unplug the tyre changer from its electrical supply source before performing any
inspection, maintenance, or cleaning procedures.
•
WARNING:
People with pacemakers should consult their physician(s) before using this product.
Operation of electrical equipment in close proximity to a heart pacemaker could cause
interference or failure of the pacemaker.
8.10 ADJUSTMENT OF PNEUMATIC LUBRICATOR AND AIR SERVICE
UNIT.
Press pedal
3 to 5 times = 1 drop of oil
into pneumatic lubricating cylinder.
If not adjust screw
.
Connect the air tube from the assist arm to the back of the main unit
$
.
Connect the tyre inflator gun to the upper connector
%
.
Connect the air supply to inlet
&
.
Pneumatic lubricator
Oil water separator
Pressure regulator
Air pressure dial
Water outlet
Oil adjustment screw
-
+
Lock
5.3 CONNECTION TO THE POWER SUPPLY
CAUTION: Risk of electric shock. Do not open.
This appliance is supplied with a moulded 3 pin mains plug for your safety. The value of the fuse
fitted is marked on the pin face of the plug. Should the fuse need replacing, ensure the substitute
is of the correct rating, approved to BS1362 and ASTA or BS Kite marked.
ASTA
BSI
The fuse cover is removable with a small plain slot screwdriver. Ensure the fuse cover is replaced
before attempting to connect the plug to an electrical outlet. If the cover is missing, a replacement
must be obtained or the plug replaced with a suitable type.
If a replacement plug is to be fitted this must be carried out by a qualified electrician.
The damaged or incomplete plug, when cut from the cable shall be disabled to prevent connection
to a live electrical outlet.
This appliance is Class I† and is designed for connection to a power supply matching that detailed
on the rating label and compatible with the plug fitted.
If an extension lead is required, use an approved and compatible lead rated for this appliance.
Follow all the instruction supplied with the extension lead.
†Earthed : This product requires an earth connection to protect against electric shock from
accessible conductive parts in the event of a failure of the basic insulation.
