DRAGON WINCH DWH 12000 HD, Руководство по эксплуатации

Страница: 42 / 218

www.dragonwinch.com
42
4. Connect the yellow M wire of the receiver, terminated
with a connector, to the longer, thin black wire of the re-
lay.
5. The blue
“antenna”
wire remains unconnected.
Connecting the wired control of the winch
The wired control has three wires: red F and two other,
terminated with connectors: blue
g
and black
i
1. Connect the red wire of the a pin on the relay.
2. Connect the blue
g
wire to the blue
h
wire of the
relay
3. Connect the black
i
wire to the black
J
wire of the
relay
F. CONNeCTION FOR WINCH MODeLS:
dwM 000 sT
dwM 500 sT
dwM 3500 sT
Connection diagram - see section F at the end of the ma-
nual.
The relay has four pins on the front panel
a
,
B
,
c
,
d
and
three connectors coming out of the relay housing: h , E , J .
Connection of power leads - battery - relay - motor
1. With the first pair of leads (
red and black
) make the
following connections:
- Use the red lead
(a)
to connect the pin with the
c
mark
on the relay with the power on the motor marked with a
“+”
or with a red washer.
- Use the black wire (b) to connect the pin with the d
mark on the relay to the negative bolt on the motor marked
with a “-” or with a black washer.
2. With the second pair of leads (
red and black
) make
the following connections:
- Connect the red
(c)
pin
a
on the relay with positive
(+)
battery terminal
- Connect the black
(d)
pin
B
on the relay with negative
(-) battery terminal
3. Connect the
E
connector of the relay with the
B
pin
of the relay
Connection of radio control (wireless).
The remote control consists of a radio signal receiver and
a transmitter (remote controller). There are five wires co-
ming from the receiver: red:
K,
black:
L,
white:
N,
yellow:
M, blue is the “antenna” .
Connect the radio control as follows:
1. Connect the red K wire of the receiver with a pin on
the relay.
2. Connect the black L wire of the receiver with the B
pin on the relay.
3. Connect the white n wire of the receiver terminated
with the connector to the
J
connector of the relay.
4. Connect the yellow M wire of the receiver, termina-
ted with a connector to the
h
connector of the relay.
5. The blue “antenna” wire remains unconnected.