DR 13 HP Pro, Руководство по безопасности и эксплуатации

Страница: 15 / 36

CONTACT US AT
www.DRpower.com
15
Before Starting the Engine
1.
Check the oil level every time you use the machine ( Figure 3 on page 10 ).
2.
Check the gasoline level (
Figure 3 on page 10
).
3.
Open the Fuel Shut-Off Valve, which is located in the Fuel Line ( Figure 1 on page 7 ).
4.
Make sure the Blade Control Knob is pushed down to the disengaged position ( Figure 1 on page 7 ).
NOTE: The Blade Control Knob must be DOWN, or the Engine will not start.
Starting
1.
Push the Blade Control Knob down to disengage the Blades ( Figure 1 on page 7 ).
2.
When starting a cold Engine, push the Throttle Control Lever up to the CHOKE position. When starting an already warm
Engine, push the Throttle Control Lever down to the RUN position (
Figure 1 on page 7 ).
3.
Turn the Key Switch to the center position (ON), and then to the START position ( Figure 1 on page 7 ) until the Engine starts,
then release. The Key will snap back to the center position (ON) and the Engine will continue to run.
4.
As the Engine warms up, slowly adjust the Throttle to the Run position. Wait until the Engine runs smoothly before each
Throttle adjustment. For maximum performance, operate the Engine with the Throttle in the RUN position.
Stopping the Engine
1.
Disengage the Blades by pushing the Blade Control Knob down.
2.
Move the Throttle Control Lever all the way down to the IDLE position and turn the Key to STOP.
3.
Remove the Key for safety. The Key has a pressure lock that prevents it from vibrating loose during operation. To remove the
Key, push it in and then quickly and firmly pull it out. If the Key becomes difficult to remove, apply a non-conductive lubricant
into the Keyhole.
NOTE: Close the Fuel Shut-Off Valve when transporting or storing the TOW-BEHIND DR FIELD and BRUSH MOWER.
Engaging the Blades
1.
Engage the Blades by pulling UP on the Blade Control Knob ( Figure 1 on page 7 ).
Stopping the Blades
1.
Push DOWN on the Blade Control Knob ( Figure 1 on page 7 ).
Inspect the area where you will be working. The site must be free of potentially hazardous obstacles such as glass, large stones,
sticks, wire, rope, and string-like materials. Make sure there are no people or animals in the area around the TOW-BEHIND DR
FIELD and BRUSH MOWER.
Never stop the engine by moving the throttle control lever to the choke position. This could cause an engine backfire resulting in
engine damage.