DR 13 HP Pro, Руководство по безопасности и эксплуатации

Страница: 11 / 36

CONTACT US AT
www.DRpower.com
11
Attaching the Out-Rigger™ Tow Bar to the TOW-BEHIND DR
FIELD and BRUSH MOWER
Tools Needed:
•
7/16" Wrench or Socket
1.
Using a 7/16" Wrench or Socket, remove the three (3) Bolts and Washers
that retain the black Pulley Cover and remove the Cover (
Figure 4 ).
2.
Locate and remove the Tow Bar Retaining Pin and Collar from the Pivot Pin
on the front of the Mower Deck.
3.
Pull the Handle of the Tow Bar Locking Pin up so its Cross Pins are above
the Tow Bar and then twist the Handle 90º so the bottom Cross Pin rests on
top of the Tow Bar (
Figure 5 ).
Tip: Enlist the help of another person to hold the Tow Bar level during the next
step.
4.
Place the Tow Bar over the Pivot Pin and install the Collar and the Tow Bar
Retaining Pin.
NOTE: The Remote Control Panel Throttle Cable and Wire Harness are routed
inside the Tow Bar housing. Use care not to pinch them when attaching
the Tow Bar over the Pivot Pin.
5.
Pull the Tow Bar Locking Pin Handle up, turn it 90º, and release the Locking
Pin into the center hole in the Tow Bar Mount Plate.
Connecting the Remote Control Panel Throttle Cable and Control
Wire Harness
NOTE: An optional Control Extension Kit is available to give you more mounting
options for your machine. You can replace the existing Throttle Cable with
a longer one and extend the existing Wire Harness. Visit our website at
www.DRpower.com to order Kit #233881 for the Briggs and Stratton
Engine or Kit #233901 for the Kawasaki Engine.
Control Wire Harness
1.
Locate the Solenoid Wire Harness with Terminals under the orange Fuel
Tank Mount (
Figure 6 ).
2.
Connect the terminals of the Solenoid Wire Harness to the terminals of the
Control Wire Harness coming from the Tow Bar (they are keyed and color
coded) by pushing them together until they snap in place.
3.
Position the Strain-Relief behind the cutout in the Fuel Tank Mount and then
pull it towards you into the cutout until it snaps in place. Make sure the Wire
Harness terminals are tucked back under the Fuel Tank Mount.
4.
Replace the black Belt Cover and secure with the three Bolts and Washers.
Figure 4
Retaining
Bolts and
Washers
Tow Bar
Retaining Pin
Collar
Pivot
Pin
Pulley
Cover
1
2
Figure 6
Fuel Tank
Mount
Solenoid
Wire
Harness
Control
Wire
Harness
Terminals
Strain-Relief
Strain-Relief
When attaching the tow bar and wire harnesses, you must first disconnect
the spark plug wire(s), keeping it away from the spark plug(s) to prevent
accidental starting of the engine.
Figure 5
Tow Bar
Locking Pin
Handle
Tow Bar
Collar
Tow Bar
Retaining Pin
Pivot
Pin
Cross Pin
Tow Bar
Mount Plate