DR 11.5 Chipper Shredder, Руководство по безопасности и эксплуатации

Страница: 17 / 36

CONTACT US AT
www.DRpower.com
17
Chapter 4: Maintaining The DR 11.5 CHIPPER SHREDDER
Regular maintenance is the way to ensure the best performance and long life of your machine. Please refer to this manual and the
Engine Manufacturer's Owner's Manual for maintenance procedures. Service intervals listed in the checklist below supersede
those listed in the Engine Manufacturer's Owner's Manual.
Regular Maintenance Checklist
P
ROCEDURE
B
EFORE
E
ACH
U
SE
E
VERY
25 H
OURS
Check Engine Oil Level 
Check General Equipment Condition 
Clean Engine Exterior & Cooling Fins 
Inspect Knife for damage and sharpness 
Check Knife Attachment Screws 
Check Hammers/Spacers for Wear, Reverse or Replace as Needed

Check Air Filter, Clean or Replace as Needed 
Check Tire Pressure

Change Engine Oil
1
st
time 5 hrs

Inspect Spark Plug, Replace as Needed 
Removing and Replacing the Engine Oil
Tools and Supplies Needed:

1/4" Allen Wrench

Rags and approved Container (for waste oil)

Engine Oil (see your Engine Manual for Oil specifications)
Note: Drain the oil when the Engine is warm; warm oil drains quickly and
completely.
1. Set the machine on a level surface, place an approved Waste Oil Container
under the front of the unit between the wheels.
1. Remove the Oil Drain Plug at the front of the Engine using a 1/4" Allen
Wrench allowing the used oil to drain completely through the drain hole and
down into the Container (
Figure 12 ).
2. Replace the Oil Drain Plug and refill with new oil through the Oil
Fill/Dipstick ( Figure 13 ). See “ Adding Oil and Gasoline ” on page 10.
Note: Be sure to use environmentally safe disposal procedures in the disposing of the
used oil.
Oil
Fill/Dipstick
Figure 13
Oil Drain Plug
Figure 12
Before performing any maintenance procedure or inspection, stop the Engine, wait five minutes to allow all parts to cool.
Disconnect the Spark Plug Wire, keeping it away from the Spark Plug.