DR 11.5 Chipper Shredder, Руководство по безопасности и эксплуатации

Страница: 18 / 36

18
DR
®
11.5 CHIPPER SHREDDER
Greasing the Wheel Bearings
Tools and Supplies Needed:

Grease Gun

Lithium Grease

Clean Cloth
1. Wipe all dirt, etc., from the Grease Fittings on both Wheels with a clean cloth
(
Figure 14 ).
2. Apply no more than three pumps of quality general-purpose lithium grease
with a hand-pumped Grease Gun to the Grease Fitting on each Wheel.
Replacing the Belt
Tools and Supplies Needed:

Two 1/2" Wrenches
1. Remove the two Bolts and Washers securing the Belt Cover using a 1/2"
Wrench (
Figure 15 ). Remove the Belt Cover.
2. Loosen the two left side Engine Mount Locknuts using a 1/2" Wrench
(
Figure 16 ).
3. Loosen the two right side Engine Mount Bolts and Locknuts using two 1/2"
Wrenches (
Figure 17 ).
4. Loosen the Tension Bolt using a 1/2" Wrench (
Figure 16
) until the Engine
can be moved enough to remove the Belt from the Clutch and Pulley.
5. Install the new Belt and adjust the Tension Bolt until the Belt only deflects
1/2" when approximately 3 lbs of pressure is applied ( Figure 18 ).
6. When the Belt is adjusted properly, tighten all four Engine Bolts, then
retighten the Tension Bolt by 1/4 turn.
Belt
Figure 18
Right Side
Engine Bolts
and Locknuts
Figure 17
Left Side
Engine Nuts
Figure 16
Tension
Bolt
Belt Cover
Figure 15
Bolts
Grease Fitting
Figure 14