2
STEP 5 – INSTALLING THE FILTER
Skip this step if your filter is already installed
When installing the Angle Stop Adapter (T-Valve) to the cold water line,
you may need to use the 1/2” x 3/8” Adapter and Teflon tape.
Turn off cold water, install T-Valve. Make sure T-Valve is turned to
“Off” position. Leave cold water off until installation is complete.
STEP 4 – INSTALL THE ANGLE STOP ADAPTER (T-VALVE) TO COLD WATER LINE
1
1
2
2
3
10 | User Manual
Using the Housing Wrench loosen the housing canister and remove the lid.
After removing the plastic wrapper from the replacement filter, install the
Full Spectrum Water Filter replacement filter into the inside of the housing
canister. Ensure the top of the replacement filter is facing towards the housing
canister lid by following the direction of the sticker on the replacement filter
that says "This End MUST Face Lid". Remove this sticker prior to installing.
Replace the lid.
Tighten the housing canister by using the Housing Wrench. (It is very important
to ensure the lid is properly closed, but NOT over-tightened, to
prevent leaking and water damage.)
Adapter
