User Manual | 11
Using the 1/4” tubing provided, cut the length of tubing needed
to connect the Full Spectrum Water Filter faucet.
Insert one end of the tubing into the Quick Connect Fitting on
the Full Spectrum Water Filter Housing lid labeled “OUT”.
Thread the Faucet Connector, included in the installation
hardware bag, onto the Faucet Shaft. Hand tighten it.
Grasp the end of the 1/4" tubing from the Full Spectrum
Water Filter Housing and insert tubing into the Quick
Connect Fitting of the Faucet Connector. Press firmly to
ensure proper connection. To test, give it a gentle tug.
STEP 7 – INSTALL TUBING FROM FULL SPECTRUM WATER FILTER HOUSING TO THE FAUCET
See Diagram to the right
Screw in Quick Connect Inlet Fittings into both sides of the Full Spectrum Water
Filter housing lid.
Using a sharp knife and the 1/4" tubing provided, carefully cut a length of tubing
to the proper length to connect the Angle Stop Adapter to the Full
Spectrum Water Filter canister.
Insert one end of the tubing into the Quick Connect Fitting on the
Angle Stop Adapter and the other end into the Quick Connect Fitting
labeled “IN” on the Full Spectrum Under-Counter Water Filter housing lid.
STEP 6 – INSTALL TUBING FROM ANGLE STOP ADAPTER (T-VALVE)
TO FULL SPECTRUM WATER FILTER HOUSING
1
2
1
2
3
3
4
REMOVAL:
Hold Quick Connect Fitting
end with thumb and index finger.
Press in on the collet ring while pulling
out the 1/4” tubing in opposite direction.
NOTE:
The tubing must be connected to the
cold water line and NOT the hot water line.
Threaded side connects
to Faucet Shaft
Faucet Connector
Quick Connect Fitting
side connects to
1/4” Tubing
1/4” Tubing
Connect to Filtered Water
