Quintaflex R96
Ceiling, Wall Model
Dr. Mach
Lamps and Engineering
59250001
Edition 01
21.02.2002 / Bak Page
16/18
4.3.3 Changing the filter disk
The dielectric filter disk between reflector and splinter
protection disk prevents a damaging heating of the
illuminated area.
The lamp may not be used without this filter.
For changing the filter disk proceed as follows:
•
Turn off the lamp.
•
Rotate the three quick-release fasteners
1
half a
turn anticlockwise so that the corresponding disk
bearer can be removed from the bottom part of
the lamp housing.
•
Slightly loosen nuts
2
, carefully bend the
retaining springs
3
apart, change and replace the
filter disk
4
.
Only use filter disks which have been
cleaned accordingly.
4.3.4 Changing the splinter protection
disk
In case you notice a reduced light quality because of
a dull splinter protection disk, it may be necessary to
change the disk.
To change the splinter protection disk proceed as
follows:
•
Turn off the lamp.
•
Rotate the three quick-release fasteners
1
half a
turn anticlockwise so that the corresponding disk
bearer can be removed from the bottom part of
the lamp housing.
•
Remove filter disk
4
as described at point 4.3.3.
•
Loosen the three nuts
2
M3, remove retaining
spring
3
and retaining ring
5
.
•
Change and replace splinter protection disk
6
and lay stay tube
7
, retaining ring and retaining
spring in the correct order on the disk bearer
according to the illustration.
•
Place nuts
2
onto the threaded bolts according
to the illustration and tighten.
•
Carefully bend the retaining springs
3
apart and
replace filter disk.
Only use filter disks which have been
cleaned accordingly.
•
Replace disk bearer and fasten by turning the
three quick-release fasteners
1
.
4
4
2
3
5
6
7
1
