65
Display Points
Alarm Point
Description
Solution
K if BAC active)
expected.
37
Dynamic
memory full
Not expected to occur.
Call DPS Tech Support (559) 454-1600
38
Notification 1
failed
A notification 1 event, such as a page or
email, was unsuccessful.
Use RPT filter debug to help diagnose
notification problems.
39
Notification 2
failed
A notification 2 event, such as a page or
email, was unsuccessful.
Use RPT filter debug to help diagnose
notification problems.
40
Notification 3
failed
A notification 3 event, such as a page or
email, was unsuccessful.
Use RPT filter debug to help diagnose
notification problems.
41
Notification 4
failed
A notification 4 event, such as a page or
email, was unsuccessful.
Use RPT filter debug to help diagnose
notification problems.
42
Notification 5
failed
A notification 5 event, such as a page or
email, was unsuccessful.
Use RPT filter debug to help diagnose
notification problems.
43
Notification 6
failed
A notification 6 event, such as a page or
email, was unsuccessful.
Use RPT filter debug to help diagnose
notification problems.
44
Notification 7
failed
A notification 7 event, such as a page or
email, was unsuccessful.
Use RPT filter debug to help diagnose
notification problems.
45
Notification 8
failed
A notification 8 event, such as a page or
email, was unsuccessful.
Use RPT filter debug to help diagnose
notification problems.
51
Expansion 1
Failed
Expansion shelf 1 communication link
failure.
Verify the number of configured NGDdx
units.
Use EXP filter debug and port LEDs to
help diagnose the problem. Verify the
addressing on the NGDdx unit.
57
Default
Configuration
The internal NVRAM may be damaged.
The unit is using default configuration
settings.
Login to the NetGuardian's web browser
and configure the unit. Power cycle to see if
the alarm clears.
58
Dip Switch
Config
Reserved for future use to enable
backwards compatibility with the
NetGuardian G2.
59
MAC Address
Not Set
The MAC Address is not set
Call DPS Tech Support - (559) - 454-1600
60
IP Address Not
Set
The IP Address is not set
See Section "Quick Start: How to Connect to
the NetGuardian via Craft Port." If not using
the NetGuardian over LAN, set the IP
address to 255.255.255.255
61
LAN hardware
error
The unit does not have a solid LAN link to
the hub, switch, or router
If connecting to a hub, you might require a
LAN crossover cable
62
SNMP
processing error
SNMP trap address is not defined and an
SNMP trap event occurred..
Check proxy connection. The serial port
data may not be getting collected as
expected.
63
SNMP
community error
Community string does not match your
SNMP master's community string.
Verify both community strings to make sure
they match.
64
LAN TX packet
drop
An error occurred transmitting data over
LAN.
Verify that you can ping both devices.
System Alarms
Содержание D-PK-NG432
