DP Audio Video DP316, Руководство пользователя

Страница: 5 / 17

3. Press the Release button to remove the front panel.
4.
Lift the top of the outer trim ring, then pull it out to remove it.
5.
Insert both of the supplied keys into the slots at the middle left
and right sides of the unit, then pull the unit out of the dashboard.
DIN REAR-MOUNT (Method B)
If your vehicle is a Nissan or Toyota
,
follow these mounting
instructions
.
Use the screw holes marked T (Toyota
),
N
(
Nissan
)
located on
both sides of the unit to fasten the unit to the factory radio
mounting brackets supplied with your vehicle.
Si de Vi ew s howi ng
Sc rew Hol es mark
ed T , N
Sc rew
Fac tor y R adi o
Mounti ng Br ack et
Sc rew
D as hboard or C onso le
To fasten the unit to the factory radio mounting brackets
,
a lign
the screw holes on the bracket with the screw holes on the unit,
and then tighten the screws (5x5mm
)
on each side
.
Note: The outer trim ring, sleeve, and the metal strap are not
used for Method B installation.
Connections
Speaker connection
Please
turn off the machine’s power before connecting
speakers, to avoid short circuit (refer to connection picture).
Note: Do not connect or touch speaker line with grounding wire
of car except as it is indicated in connection picture, otherwise the
unit can be badly damaged.
Grounding wire connection
Connect black wire with grounding terminal of car. Or connect it to
chassis of car. It is suggested to connect to metal of car to get best
performance.
Power connection
First, connect yellow memory power line(15Amp fuse) with +12V
w/o switch power supply (always on), then connect red power line
with +12V auxiliary power supply of ignition.
Antenna connection
Insert coaxial antenna plug of car into antenna socket.
Note: Check connection and change to same current fuse. Bad
damage can occur if larger-rated fuse is used (blown fuse).
Current noise
This unit will not sound good with much background noise .
7 8