DP Audio Video DP316, Руководство пользователя

Страница: 4 / 17

1. Make sure the ignition is turned off, and then disconnect the
cable from the vehicle battery
'
s negative (-) terminal.
2.
Disconnect the wire harness and the antenna.
3.
Press the Release button on the front panel and remove
the control panel (see the steps of removing the front panel
).
4.
Lift the top of the outer trim ring, then pull it out to remove it.
5. The two supplied keys release tabs inside the unit
’
s sleeve
so
you can remove it.Insert the keys as far as they will go(with the
notches facing up) into the appropriate slots at the middle left
and right sides of the unit. Then slide the sleeve off the back of
the unit.
Slee ve
L K ey
Ou te r Trim Rin g
Fron t Panel
9.
To further secure the unit, use the supplied metal strap to
secure the back of the unit in place. Use the supplied hardware
(hex nut [5mm] and spring washer) to attach one end of the
strap to the mounting bolt on the back of the unit. If necessary,
bend the metal strap to fit your vehicle
'
s mounting area. Then
use the supplied hardware (tapping screw [5x25mm] and plain
washer) to attach the other end of metal strap to a solid metal
part of the vehicle under the dashboard. This strap also helps
ensure proper electrical grounding of the unit.
Note: Install the short threading terminal of the mounting
bolt to the back of the unit and the other long threading terminal
to the dashboard.
Spring Washer Hex Nut
Metal Strap
Mounting Bolt
Plain Washer
Tapping Screw
R Ke y
6. Mount the sleeve by inserting it into the opening of the
dashboard and bending open the tabs located around the
sleeve with a screwdriver. Not all tabs will be able to make
contact, so examine which ones will be most effective. Bend
open the appropriate tabs behind the dashboard to secure the
sleeve in place.
7
. Reconnect the wire harness and the antenna. Be careful not to
pinch any wires or cables.
8. Slide the unit into the sleeve until it locks into place.
10.
Reconnect the cable to the vehicle battery
’
s negative
( - )
terminal. Then replace the outer trim ring and install the unit
'
s
front panel (see the steps of installing the front panel
).
Removing the unit
1.
Make sure the ignition is turned off, then disconnect the cable
from the vehicle battery
'
s negative (-) terminal.
2.
Remove the metal strap attached to the back of the unit (if
attached).
5 6