Model 401 & 403 Pass-Thru
Service and Installation Instructions
99-21972-S001 Rev. C
- 48 -
1
6. Refer to the
“Wiring Diagrams and Orientation” section.
a. Place the extrusion notch toward the bottom of the Mullion.
b. Using a Phillips screw driver, thread a #8 tapping screw through the
plastic extrusion.
7. Position the center punch directly over the vertical line and within the plastic
extrusion notched cutout, establish a dimple.
8. Use a power drill and
(3/8”) 0.375” dia. drill bit, drill (1) hole.
9. Snap the LED fixture into the plastic extrusion. Refer to
“Wiring Diagrams
and Orientation
” and “Parts List”.
10. Thread the LED wires through the 3/8
” hole.
11. Align the LED fixture with the vertical lines made in step 2 and using a
center punch, establish two dimples, one at the top and one at the bottom of
the end clips.
12. Use a power drill and
(1/8”) 0.125” dia. drill bit. Drill two (2) holes through
the LED top and bottom mounting brackets through the plastic extrusion.
13. Using a Phillips screw driver, thread a #8 tapping screw through the plastic
extrusion
14. Connect the LED Light fixture wire connectors to the LED power supply.
NOTE: The fixtures are polarity sensitive. Pay close attention when
wiring the red (+) wires of the fixture to red wires of the driver,
and the blue (-) wires of the driver to the black (-) wires of the
fixture.
15. Turn the power on and verify the LED fixture(s) are working.
