Lit. No. 96582, Rev. 00
2
April 1, 2016
85200, 96500 CabCommand HAND-HELD CONTROL
Control Functions – Straight Blade
Snowplows
Pressing the four diamond‑shaped buttons in the
center of the control face will result in the blade
movements described in the following table.
Function Description of Operation
RAISE
Press this button to raise the blade and cancel
the FLOAT mode. Function times out after
3.0 seconds.
LOWER
Press this button to lower the blade. Release
the button to stop the blade at desired height.
FLOAT*
Press the
LOWER
button and hold 3/4 second
to activate this mode. The FLOAT light in
the upper left corner of the control face will
illuminate. The blade will lower to the ground
surface and follow the contour of the surface
as it dips or rises. Function does not time
out; however, the control will shut down after
20 minutes of nonuse.
Press the
RAISE
button momentarily to cancel
FLOAT. Angling left or right will interrupt
(pause) the FLOAT function, but the FLOAT
light will stay illuminated and FLOAT will
resume when angling is complete.
L
(Angle
Left)
Press this button to angle the blade left.
Function times out after 5.5 seconds.
R
(Angle
Right)
Press this button to angle the blade right.
Function times out after 5.5 seconds.
*
FLOAT mode activates immediately when the One‑Touch FLOAT
feature is enabled. See the One‑Touch FLOAT section for more
information.
NOTE: If a control function times out before
desired blade movement is complete, release the
button and press it again.
OPERATING THE CONTROL
1. Turn the vehicle ignition switch to the "ON" or
"ACCESSORY" position.
2. Press the ON/OFF button on the control to
turn the control ON. The power indicator light
glows red, indicating that the control is ON. The
indicator light glows red whenever the control
and the vehicle ignition switch are both ON and
the electrical connections to the snowplow are
completed.
The ON/OFF button operates as an emergency
stop, if required.
Function Time-Outs
All control functions, except LOWER/FLOAT, time out
(stop) automatically after a period of time. This is to
limit the amount of electrical energy required from the
vehicle.
While the control operations are the same, the
time‑outs vary by snowplow model.
NOTE: If a control function times out before
desired blade movement is complete, release the
button and press it again.
Automatic Shutdown
The control will automatically turn OFF after being
idle for 20 minutes. To reactivate the control after a
shutdown, press the ON/OFF button.
Smooth Stop
The control automatically allows the blade to coast to
a stop when a control button is released. This results
in smoother operation, reduces the shock to the
hydraulic system and increases hose and valve life.
See the FLEET FLEX Electrical System section for
more information about this feature.
WARNING
The driver shall keep bystanders clear of
the blade when it is being raised, lowered or
angled. Do not stand between the vehicle and
the blade or within 8 feet of a moving blade. A
moving or falling blade could cause personal
injury.
RAISE
LOWER
R
L
ON/OFF
FLOAT
1
3
2
4
S C O
O
P
R
E
T
R A C T
W
IN
G
W I N
G
FLOAT Light
(green)
