6.5.2 Rinsing
NOTICE!
Material damage due to unsuitable
rinsing agent
If the rinsing agent reacts chemically with
the components or the material, compo-
nents get damaged.
– Use only the rinsing agents that are
compatible with the components and
the material.
– Refer to safety data sheet of material
manufacturer.
Guide the detergent via the material connec-
tion.
Rinse the spray gun in the following cases:
After end of operation
Before every change of material
Prior to cleaning
Prior to dismantling
Before a long time of non-use
Before placing in storage
Rinsing intervals depend on the
material used.
Personnel:
Operator
+ additional qualification explosion pro-
tection
+ Additional qualification high pressure
Protective equipment:
Protective workwear
Safety boots
Protective gloves
Eye protection
Respiratory protection device
Requirements:
Material pressure is present.
1. Unscrew and remove spray jet screen.
2. Rinse the spray gun with an appropriate
rinsing agent until the rinsing agent runs
clean without any material residue.
3. Ensure proper disposal of the exiting
material and rinsing agent.
4. Fit spray jet screen. Tighten by hand.
5. Purge the spray gun again, until the
detergent comes out without any material
residue.
6. Shut off detergent supply.
7
Cleaning and maintenance
7.1
Safety recommendations
WARNING!
Danger of fire and explosion
Flammable coating materials and their
detergents and cleaning agents can cause
a fire or an explosion.
– Ensure that the flashpoint of the fluid is
at least 15 K above the ambient tem-
perature.
– Note explosion group of the fluid.
– Follow safety data sheets.
– Ensure that forced ventilation and fire
protection equipment are in operation.
– Do not use sources of ignition and
open light.
– Do not smoke.
Cleaning and maintenance
05/2018
EcoGun AL MAN 300 - MSG00016EN
14/44
