6.6
Guiding the spray gun
Protective equipment:
Protective gloves
Safety boots
Protective workwear
Eye protection
Respiratory protection device
Use ear protection
Fig. 8: Guiding the paint gun
1. Guide the spray gun as follows:
Guide spray gun at 90 degrees to the
surface.
Maintain a distance of 15 to max.
25 cm to the surface.
The distance can vary for
effect coatings.
6.7
Rinsing
6.7.1 Safety recommendations
NOTICE!
Material damage due to unsuitable
rinsing agent
If the rinsing agent reacts chemically with
the components or the material, compo-
nents get damaged.
– Use only the rinsing agents that are
compatible with the components and
the material.
– Refer to safety data sheet of mate-
rial manufacturer.
6.7.2 General notes
When rinsing, use fluid to remove inner
soiling from components.
6.7.3 Rinsing spray gun
Protective equipment:
Use ear protection
Eye protection
Respiratory protection device
Protective workwear
Protective gloves
Rinsing spray gun:
After end of work
Before every change of material
Prior to cleaning
Prior to dismantling
Before a long time of non-use
Before placing in storage
Additional rinsing intervals
depend on the material used.
Preparation for rinsing
1. Disconnect the air hose from the spray
gun.
Fig. 9: Removing the air cap
2. Loosen cap nut (1).
Operation
12/2016
EcoGun 249 - MSG00014EN
11/40
