dormakaba USA Inc. Remote Disable HW/SW Setup 7044.0822 Rev A 08/22 |
4
4.
In the PC Link window, select Program from the left-hand column.
5.
Verify that the correct COM port is selected. You can use the drop-down menu to
switch ports.
6.
Use the drop-down menu to select the Master user ID and enter the
corresponding combination in the space provided.
7.
From the list of system settings, ensure that Input Signal is checked off. You can
also check off any other setting you want to update/program, or check Select All
to update/program all system settings.
8.
Connect the Keypad to the PC by doing the following:
a.
Plug the 700 Series USB Dongle into the USB Port of the PC.
b.
Plug the USB-connector end of the cable into the dongle.
c.
Plug the mini-USB end of the cable into the mini-USB port on the Keypad.
9.
On the Keypad, enter a valid User ID and the corresponding combination (the
same ID and combination used in step 6).
10.
Using the arrow buttons on the Keypad, navigate through the Main Menu and
select PC Link. The LED on the Keypad will illuminate red, and “Connect
Software” will appear on the keypad’s display screen.
11.
In the software client PC Link window, click the Send icon located at the top-
right of the screen.
A progress bar will appear onscreen. As the Keypad is programmed, “PC Link active”
will appear on the display screen and the LED will illuminate green.
12.
When the programming is complete, “PC Link closed” will appear on the Keypad’s
display screen, then the system will restart.
