•
Enter the desired default gateway or leave empty and select “OK”.
•
Enter the desired subnet mask and select “OK”.
•
Enter the desired Ethernet networking configuration and then select “OK”.
•
Select “Yes” for eth1.
•
Select “No” for "Removable device".
•
Select “No” for automatically configure device with DHCP.
•
Enter the IP address of eth1 and select “OK” – in the example, enter 192.168.10.12.
•
Enter the desired default gateway or leave empty and select “OK”.
•
Enter the desired subnet mask and select OK – in our example, enter the same subnet
mask as the projector: 255.255.255.0.
•
Leave the system’s domain name servers empty and select “OK”.
•
Exit the set up utility.
•
To verify the setup go to “
Menu → Doremi Apps. → Diagnostic Tool
” and verify the IP
Address under the Diagnostic Tool “System” Tab.
Note
: The configuration for Ethernet 2 that might be asked by the Ethernet configuration wizard
is not needed at this point. It is ok to skip this step if asked for the configuration.
_____________________________________________________________________________________
SHV.OM.001293.DRM
Page 23
Version 1.3
Doremi Cinema LLC Confidential
