9000-065-J-9-11
23
3.2 Continued
Switch 1
Must OPEN
the primary operator’s gate upon initial AC power up and open command. If the first open command
begins to close the gate, turn AC power off and reverse this switch.
Switch 2
Must OPEN
the secondary operator’s gate upon initial AC power up and open command. If the first open command
begins to close the gate, turn AC power off and reverse this switch. This switch will be set the opposite of switch 1 (eg. If
switch 1 is OFF, then switch 2 will be ON).
Switch 3
Determines that a device wired to terminal #4 is a normal full open command
OR
terminal #4 becomes the output
from the exit loop detector that is plugged into the EXIT Loop port in the circuit board (Used for specialized functions).
Switch 4
Turns the auto-close timer on or off. Maximum time that the close timer can be set for is approximately 23 seconds.
Switch 5
Determines if an input to terminal #6 (Photo Sensors)
AND/OR
reverse loops will reverse
OR
stop a
CLOSING gate
.
A tailgating vehicle
can activate
terminal #6 (Photo sensors) and/or reverse loops
while
the gate is in the closing cycle from
the previous vehicle’s authorized entry:
If
switch 5 is turned
OFF
(Reverse), the closing gate that gets activated by a tailgating vehicle will reverse back to the open
position, possibly allowing the tailgating vehicle
unauthorized entry while the gate is reversing back to the open position
.
If
switch 5 is turned
ON
(Stop), the closing gate that gets activated by a tailgating vehicle will stop, partially or completely
blocking the pathway,
NOT
allowing the tailgating vehicle to enter without proper authorization. The gate will not move until all
sensors are clear, usually forcing the tailgating vehicle that activated the sensors to back away from the gate. The gate will then
continue until closed, helping prevent the tailgating vehicle from unauthorized entry.
Switch 6
Sets up the circuit board for a single gate operator or primary / secondary (dual) gate operators.
Switches 7-8
These work in conjunction with each other and determine when the relay on the board will be activated. This relay
can be used as a switch for various functions such as illuminating a warning light when the gate is moving, or turning on a
green light when the gate is full open.
Switch 1
Turning the quick-close feature on will cause the auto close timer to close the gate after 1 second, regardless of the
setting of the auto close timer potentiometer. This will also cause an
opening gate
to stop and reverse when the reverse loops
and/or photo sensors are cleared. This feature, along with turning SW 1, switch 5
ON
above, is useful to help prevent tailgating
vehicles from unauthorized entry.
Switch 2
If a magnetic lock is not used with the gate operator, leave this switch in the OFF position. Turn this switch ON if a
magnetic lock is used and connected to terminals 9 and 12. This applies magnetic lock power and logic to these terminals (NC).
Switch 3
MUST be turned ON for the Model 9000.
Switch 4
MUST be turned OFF for the Model 9000.
1
ON
2
3
4
5
6
7
8
SW 1 (Top 8 Switches)
Typical
Settings
SW 2 (Bottom 4 Switches)
Typical
Settings
1
ON
2
3
4
Switch Definitions
Содержание 9000-080
Страница 2: ......
Страница 43: ...9000 065 J 9 11 41...
