DoorHan SHAFT-20, Инструкция по установке и эксплуатации

Страница: 7 / 12

7
OPERATOR INSTALLATION
4.6. ON-SHAFT INSTALLATION
Prior to installation make sure, that the door is in good working condition and the torsion springs balance the
door leaf. Install the operator as described below in paragraphs 4.2 or 4.3.
• Install a mounting bracket (pos. 1) on the wall using screws. The mounting bracket is installed to the left
of the door (inside view of the door). Release the operator via the release knob (see paragraph 4.5).
• Install a locking ring (pos. 2) on the door shaft (pos. 3).
• Disconnect a limit switch ring (pos. 4) and install it on the door shaft (pos. 3).
• Install the operator (pos. 5) on the door shaft (pos. 3).
• Install a key (pos. 6) in the shaft and operator key way (check the correct position of the key).
• Fix the operator to the mounting bracket (pos. 1) by means of three bolts (pos. 7).
• Install the limit switch ring (pos. 4) on the operator shaft.
• Install the locking ring (pos. 2) closely to the operator and fix it.
• Disconnect a limit switch screw (pos. 8) into the limit switch ring (pos. 4).
• Install a mounting plate (pos. 9) of the control unit to the mounting bracket (pos. 1).
• Fix the control unit (pos.10) on the mounting plate (pos. 9) of the control unit.
Figure 3
1
3
9
10
2 7
6 4
8
5