8
6. PROGRAMMING
DIP switches are used to switch between the operating modes of the control unit board.
WARNING!
Prior to switching between the operating modes turn the power supply OFF.
When using the device for the first time make sure the DIP switches 1 and 2 are in correct position.
6.1. DIP SWITCHES
Table 6.1.1. DIP switches operation
DCUН-2 operating mode
DCUН-3 operating mode
DIP 1 = Off
DIP 1 = Off
DIP 2 = Off
DIP 2 = On
DIP 3 is used to enter the advanced menu.
DIP 3 = Off (main menu)
DIP 3 = On (advanced menu)
DIP 3 is used to enter the advanced menu.
DIP 3 = Off (main menu)
DIP 3 = On (advanced menu)
DIP 4 is not used
DIP 4 is not used
Menu screen shows dH2
Menu screen shows dH3
In DCUH-2 mode each operation of the door and dock leveler is displayed on the menu screen accordingly (see Ta-
ble 6.1.2).
PROGRAMMING
* Connection scheme refers to DoorHan operators of Shaft series only.
Fig. 5.5. Connection scheme of lip inductive position sensor for DCUH-2 control unit*
Shaft operator
control post
Lip inductive
position sensor
Shaft operator control board terminals
brown
white
black
blue
red
COM
OPEN
STOP
CLOSE
+24V
