Donati DRH 1 Series, Инструкция по эксплуатации

Страница: 107 / 130

MAN16MG05
instructions for use series drh
1/2/3/4 -
dst
/
n
/
s
-
dst
/
r
-
drt
6.5.1 Disassembling of the hoist
• Remove the live current to the trolley pushing the emergency stop button -1-; put the lever of the disconnecting
switch in the ”O” or “OFF” position, reach the working zone safely, bringing to a height the push-button panel to
prevent it being activated from the ground (fig. 163).
• Operating at a height disconnect all the electrical connections inside the connection frame or incorporated control
board.
3A) Hoist in set-down execution:
• Put a 2-rope fall sling connecting the handling ends inside the eyebolts (fig. 164) of the hoist.
• Remove the fixing plate
-1- of the pivot -3- by unscrewing the screws -2- . Take out the fixing pivots -3- from the
respective slots (fig. 165).
• Lift with care and position the hoist in the foreseen place.
The handling of the hoist must be carried out SOLELY by using a LIFTING apparatus and with the
help of suitable slings fixed to the suspension eyebolts.
fig. 163 fig. 164
fig. 165
3
2
1
106 instructions for use series drh
1/2/3/4 -
dst
/
n
/
s
-
dst
/
r
-
drt
MAN16MG05
107
3B) Hoist in suspended execution:
• Put a pallet ready of dimensions adequate for the loading forks on the forklift truck.
• Bring the pallet under the hoist until the feet of the hoist are in contact with the surface of the pallet (fig. 166).
• Remove the fixing plates
-1- , by unscrewing the screws -2- and taking out the fixing pivots -3- from the respective
slots (fig. 167).
• Lower with caution the loading forks of the forklift truck to position the pallet in the required place.
6.5.2 Disassembling of the hoist with single girder trolley
• Remove the live current to the trolley pressing the emergency stop button -1- ; put the lever of the disconnecting
switch in the ”O” position, reach the working zone safely, bringing to a height the push-button panel to prevent
it being activated from the ground (fig. 168).
• Operating at a height disconnect all the electrical connections inside the connection frame or any control board
incorporated.
• Put a pallet of adequate dimensions ready on the loading forks of the forklift truck.
• Bring the pallet under the hoist until the feet of the hoist are in contact with the surface of the pallet. Lift slowly
for few centimetres to detach the wheels from the girder (fig. 169).
The handling of the hoist positioned on the pallet must be carried out SOLELY by a LOWERING
operation with the help of a forklift truck, or with a platform which can be raised or with other
means suitable for the purpose.
The handling of the hoist/trolley unit positioned on the pallet must be carried out SOLELY by a
LOWERING operation with the help of a forklift truck, or with a platform which can be raised or with
other means suitable for the purpose.
For trolleys not supplied by DONATI SOLLEVAMENTI S.r.l. see the specific procedures of the relative
manufacturer.
fig. 166
fig. 167
fig. 168 fig. 169
3
2
1
KMAN16MG05