Donaldson Torit WSO 10, Инструкция по установке и эксплуатации

Страница: 8 / 40

Donaldson Company, Inc.
8
CAUTION!
• Failure to lift the collector correctly
can result in severe personal injury
and/or property damage.
• Use appropriate lifting equipment
and adopt all safety precautions
needed for moving and handling the
equipment.
• A crane or forklift is recommended
for unloading, assembly, and
installation of the collector.
• Location must be clear of all
obstructions, such as utility lines or
roof overhang.
Electrical Wiring
CAUTION!
• Electrical installation must be
performed by a qualified electrician
and comply with all applicable
national and local codes.
• Lock out electrical power sources
before performing service or
maintenance work.
• Do not install in classified hazardous
atmospheres without an enclosure
rated for the application.
The only component requiring electrical power is
the blower motor.
1. All electrical wiring and connections, including
electrical grounding, should be made in
accordance with the National Electric Code,
NFPA No. 70-latest edition.
2. Check local ordinances for additional
requirements that apply.
3. The appropriate wiring schematic and electrical
rating must be used. See unit’s rating plate for
required voltage.
4. An electric disconnect switch having adequate
amp capacity should be installed in accordance
with Part IX, Article 430 of the National
Electrical Code, NFPA No. 70-latest edition.
Check unit’s rating plate for voltage and
amperage ratings.
5. Refer to the wiring diagram for the number of
wires required for main power wiring and
remote wiring.
Rigging Instructions
Suggested Tools & Equipment
Crane or Forklift Pipe Wrenches
Slings, Spreader Bars, Socket Wrenches
and Clevis Pins
End Wrenches
Drift Pins Large Crescent Wrench
Clamps Drill and Drill Bits
Screwdrivers Pipe Sealant
Hoisting Information
1. Use all lifting points provided.
2. Use clevis connectors, not hooks, on lifting
slings.
3. Use spreader bars to prevent damage to units’
casing. Refer to the Spreader Bar Lifting Detail
in the WSO 20 Floor Mount Stand Installation
Section.
4. Check the Specification Control drawing for
weight and dimensions of the unit,
subassemblies, and components to ensure
adequate crane capacity.
5. Allow only qualified crane operators to lift the
equipment.
6. Refer to applicable OSHA regulations and local
codes when using cranes, forklifts, and other
lifting equipment.
7. Lift unit and accessories separately, and
assemble after unit is in place.