Donaldson Torit DWS 4-1, Инструкция по установке и эксплуатации

Страница: 16 / 44

13
Donaldson Company, Inc.
Soft Sided Weld Curtain Booth
8.13
1.00
1.25
0.281 Dia typ.
Bracket Detail
4. Insert the foot pad and corner bracket into the front
legs.
5. Insert the eight (8) roller hooks into the side channel.
Install one end of the side channel into the end
bracket mounted to the power module. The other
end of the side channel should be installed into the
corner bracket. Repeat these steps for the opposite
side of the unit.
6. Install each end of the front channel into the corner
brackets on each of the front legs. The front channel
should extend past the side channels in order to lock
in the roller hooks. Square the entire frame assembly
and tighten all set screws on the end, corner, and
coupling brackets. Anchor leg foot pad to the floor.
7. Install the self-adhesive hook-and-loop fastener
around the top of the channels and angles on the
power module. Install the clear plastic roof.
8. Install the self-adhesive hook-and-loop fastener strip
down the outside of the side angles (2 places) and on
the outside surface of the front legs. Hang the tinted
side curtain on the roller hooks. Attach the side
curtain to the hook-and-loop strips. Repeat this for
the opposite side of the booth assembly.
Soft Sided Weld Curtain Booth Assembly
DWS Models 4-2, -3, -4
1. Position the power modules in-line so fronts are even
and two sides are touching face-to-face. Position the
first power module and remove lifting eyes, repeat
this for each additional power module.
2. Remove and reuse the existing bolts and washers
to install the joining strips in between the power
modules.
DWS Models 6-1, -2, -3
1. For DWS Models 6-2 and -3, check assembly
drawings for power module spacing positions. Also,
a spacer panel will need to be installed in between
the power modules on these models. See drawings
for details.
2. Install the side panels on each end of the power
module assembly. Remove and reuse the existing
bolts and washers on the front of the cabinet.
DWS Models 4 and 6
3. Install the side and top angles (3 places) with the
existing hardware from the front of each power
module. Attach the end brackets (2 places) to the
outer ends of each power module with the provided
hardware.
Note: for the DWS Models 4-2, -3, -4 only- Four (4)
holes will need to be drilled in the front panel of the
power module in order for the end brackets to be
attached. See Bracket Detail for hole location and
size.