Donaldson Torit DWS 4-1, Инструкция по установке и эксплуатации

Страница: 12 / 44

9
Donaldson Company, Inc.
Acoustic Hard Sided Booth Assembly
Note: Use M8 x 45 mm bolts to fasten the side rail
channels.
Use M8 x 35 mm bolts to fasten the top support
channels.
Use M8 x 20 mm bolts for the remainder of the
assembly.
1. Fasten the module side angles to the right and left
side of the assembled power modules.
2. Fasten the top panel angle to the top front of each
power module.
3. Assemble two booth panels and a side panel angle to
form a wall unit.
4. Attach wall to the outside of the power module side
angle.
5. Fasten the side-rail channels to the wall using
M8 x 45 mm long bolts, flat washers, and hex nuts.
Note: The side-rail channel with four bolt holes fits
on the outside bottom of the walls and the
side-rail channel with three bolt holes fits on
the inside of the walls about midway up. Do
not fasten the inside channel until the acoustic
panels have been installed.
6. Bolt the gussets to the right and left support legs
and fasten the support legs to the edge of the
corresponding walls.
7. Bolt the top support channel to the gussets.
Note: The DWS-2 requires one top support channel.
DWS-3 and DWS-4 require two top support
channels. When assembling the DWS-3 or
DWS-4, bolt the two top support channels and
the top support tie-in together and then bolt to
the gussets.
Roof panels are not intended
as platforms. Personnel should
use ladders or other appropriate equipment to
avoid risk of personal injury and/or property
damage.
8. Install and bolt the booth roof panels in place.
Note: Temporary roof support during assembly is
not required. The top panel angles and the top
support channels support the roof panels.
9. Attach the splicer plate to the top panel angles with
the roof panels.
10. Install the acoustic panels to the power modules,
booth roof, and walls.
11. Secure acoustic panels with nylon Christmas Tree
™
clips supplied.
12. Install flexible protective caps over exposed end of
Christmas Tree clips.
13. Tuck the edges of the booth acoustic panels into the
return flanges of the booth panels.
14. See light fixture mounting and wiring.
Christmas Tree™ Clips is a trademark of ITW Fasnex
®