Collector Stand
1.
Install customer-supplied 3/8-16 anchor bolts in the floor
extending 1 1/2-in above surface.
2. Level the collector stand and tighten anchor bolts securely.
3. Lift the collector and remove the bolts from the access
panel located on the bottom of the collector. (Existing
sealant will temporarily hold access panel in place without
bolts). Align mounting panel holes with access panel
holes and secure using existing bolts. Mounting panel will
secure against bottom of access panel.
4. Adjust the stand height by loosening the four locking bolts
on the upper portion of the stand. Slide this section up to
obtain the required height. Tighten bolts securely. Do not
adjust the stand over 102-inches.
5.
Using a crane or forklift, lift the collector into position over
the stand and lower slowly.
6. Fasten the top plate of the stand to the collector using the
bolts removed in Step 3.
7. Tighten all hardware and remove crane.
Cart
1. Turn the collector on its back with the door facing up.
2.
Select a front, side, or back location on the hopper for the flex-
duct. Choose the location that provides the shortest duct length.
3.
Apply sealant to the hopper top flange. Position the hopper so
that the inlet hole is directed toward the machine center. See Cart Installation illustration.
4.
Align the hopper flange bolt pattern with the bolt pattern on the inlet and fasten using the hardware supplied.
5. Remove and discard the eight bolts from the motor access panel. Do not remove the panel; it is sealed to the collector.
6. Lay the cart frame assembly on the ground. Align the cart to the collector at the motor access panel location. Bolt the collector
to the cart using eight M6 x 38mm bolts and washers supplied.
Collector Stand
stand
extension
hex nut
flat washer
flat washer
lock washer
locking bolt
base
102-in
maximum
mounting
panel
Donaldson Company, Inc.
25
