Domino A-SERIES, Руководство по эксплуатации и обслуживанию

Страница: 251 / 337

APPENDIX A : INSTALLATION
27080 Issue 1 Sept 98 A--11
Beeper
(1) Press the Machine Setup key.
(2) Use the scroll keys to search through the key options along the
bottom of the screen and select Beeper .
(3) Use the increment keys to select Enabled or Disabled (see also pg.
5--35).
Select Exit from the key options along the bottom of the screen.
To Create a Print Sample
WARNING: During the following procedure, the print head
must be directed into a beaker made of conducting
material which is securely connected to
ground/earth, as electrostatic charges on the ink
drops used for printing could cause a fire hazard.
The printer is now ready to print messages. It will be necessary to have
the jet running and a message ready to print. If required, refer to the
introduction to message creation and printing, pg. 3--7.
(1) Press the Service key. Enter the password if required.
(2) Use the scroll keys to search through the key options along the
bottom of the screen and select External I/F .
(3) Use the cursor keys to highlight Stroke source and use the increment
keys to select Internal .
(4) Set the character width to a suitable value for the message -- see pg.
A--10.
(5) Select Product Sequence .
(6) Select Start Cont .
(7) Take a print sample by sweeping a piece of card under the print
head and check the print quality. If required adjust print height,
etc. as above.
(8) Return to Service, External I/F and Product Sequence
(9) Select Stop , then select Exit to return to the External I/F screen. The
printer will then revert to external product detection when it
auto--detects an external print go signal.
(10) Select OK from the key options along the bottom of the screen to
return to the Service screen.
Beeper
Exit
External
I/F
Product
Seq.
Start
Cont
Exit
OK