EN
RM122, RM123
Using the refrigerator
21
➤
Operate the piezo igniter (fig.
f
1, page 7) several times at intervals of
about 2 seconds.
➤
Hold down the temperature regulator for an additional 15 seconds after
the burner has ignited and a flame is visible through the sight glass.
After that, the automatic flame failure device is ready for operation.
Gas operation (RM123)
➤
Ensure that the gas supply is turned on and the 230 V
w
connection cable
is disconnected from the mains socket.
➤
Set the rocker switch to “I” (fig.
g
1, page 7) to turn on the electronic ig-
nition.
✓
The rocker switch begins to flash.
➤
Turn the temperature regulator (fig.
g
2, page 7) to position “3”.
➤
Press in the temperature regulator and hold it down.
✓
Once the burner is lit, the rocker switch stops flashing.
➤
Hold down the temperature regulator for an additional 15 seconds after
the burner has ignited.
After that, the automatic flame failure device is ready for operation.
Operating with 230 V
w
(RM123 only)
➤
Make sure that temperature switch and toggle switch are turned off and
the 12 V
g
supply is interrupted.
➤
Connect the refrigerator with the mains socket.
➤
Switch on the refrigerator by switching the temperature controller
(fig.
h
1, page 7) to any level.
Operating with 12 V
g
I
➤
Make sure that the gas supply and the 230 V
g
supply are interrupted.
➤
Connect the power plug with the 12 V
g
-cigarette lighter.
NOTE
Disconnect the refrigerator and the battery with the engine off
since it is otherwise discharged.
Содержание RM122
