EN
Installing the refrigerator
RM122, RM123
16
7.4
Fixing the refrigerator
➤
Fix the refrigerator using blocks of wood laterally:
Fix the blocks of wood on the side of the recess from the front to the back
(fig.
8
1, page 5).
7.5
Installing exhaust pipe
The exhaust pipe must lead the exhaust gases directly to the outside.
➤
Make an opening with a maximum diameter of 70 mm at the opening in
the vehicle wall.
➤
Put the T-piece (fig.
9
2, page 5) on the opening of the refrigerator.
➤
Lead the extension tube (fig.
9
1, page 5) of the venting kit outside
through the opening.
The vent cover must touch the outer wall of the vehicle. If this is not the
case, you have to shorten the extension tube (fig.
9
1, page 5).
A
I
To shorten the extension tube, proceed as follows:
➤
Insert extension tube (fig.
9
1, page 5) and tail (fig.
9
2, page 5) into
each other.
➤
Measure the area between the vent cover and outer wall (fig.
0
X,
page 5).
➤
Transfer the measurement to the end of the extension tube (fig.
0
Y,
page 5).
➤
Shorten the extension tube accordingly.
➤
Secure the end with the opening of the refrigerator with a screw (fig.
9
,
page 5, ).
NOTICE! Risk of damage!
Do not extend the exhaust pipe, otherwise the water vapour con-
denses in the exhaust pipe and runs back into the unit. The burner
can be damaged.
NOTE
If the vehicle wall at the outlet of the exhaust pipe is not vertical or
flat, you have to fill the feed cover plate below with a non-combus-
tible material. The cover plate must be parallel to the back wall of
the refrigerator.
Содержание RM122
