EN
Connecting the refrigerator
RM122, RM123
18
7.8
Changing door decor
A
You can change the door decor. The door decor can consist of stainless
metal or plastic laminate and must have the following dimensions:
485 x 350 x 0.5 – 3 (H x W x D in mm).
Proceed as follows to change the door decor:
➤
Turn the refrigerator on the side.
➤
Remove the three screws on the bottom of the door frame.
➤
Pull out the decor.
➤
Slide the new decor into the opening.
➤
Screw the three screws back in.
➤
Wait a few hours before starting the refrigerator.
8
Connecting the refrigerator
8.1
Connecting igniter (RM123 only)
Use a cable with a diameter of 0.5 mm² and a fuse with 0.5 or 1 A.
➤
Connect the terminal block of the igniter with the plus and minus pole of
the battery (fig.
b
1, page 5).
8.2
Connecting to 12 V
g
the device is connected with a 12-V-plug to a 12-V-socket
➤
Connect the refrigerator as shown in fig.
c
, page 6.
➤
Fit a suitable fuse to the control cable.
➤
Connect the control cable to the connected positive terminal (terminal 15).
➤
Install a relay between refrigerator and battery to prevent the battery is
completely discharged accidentally when the engine is switched off.
NOTICE! Risk of damage
Lay the refrigerator on the side only, never on the backside.
Otherwise the aggregate may be damaged.
Содержание RM122
