background image

TROUBLESHOOTING

The Refrigerator Does Not Cool Properly

A.

Burner jet clogged.
Clean. (See section Maintenance & Service, Item 2.
Periodic Maintenance, Paragraph E. Item 1-14.

B.

Check level of refrigerator.

C.

Venting problem.
Restriction in air flow across cooling unit.

D.

Heavy frost buildup on evaporator fins.
Defrost.

E.

Flue baffle not inserted properly in flue tube.

F.

Improperly set thermostat.
See section Operating Instructions, part Start Up
Instructions.

G. Burner dirty.

Clean. See section Maintenance & Service, Item 2.
Periodic Maintenance, Paragraph E. Item 1-14.

H.

LP gas pressure low at burner.
Set main regulator so pressure does not drop below
11 inches water column at pressure tap.

I.

Burner not located properly under flue tube.
Relocate.

J

Burner damaged.
Replace.

K.

Odors from fumes.
1. Dislocated burner.
2. Damaged burner.
3. Dirty flue tube.

L.

FUSES
1. Refrigerator AC Supply.
2. Control system. See page 12, part Fuses.

NOTE: AVOID SPRAYING WATER THROUGH THE
REFRIGERATOR VENTS WHILE WASHING YOUR RV.

All the above instructions are to be followed closely. The
refrigerator is quality-guaranteed. However, we are not
responsible for any failures caused by improper adjust-
ments and unfavorable installation conditions. Contact
service point or distributor service dept. for assistance.

Replacement Parts Suppliers: See page 1.

INSTRUCTION FOR MOUNTING
THE DOOR PANEL

The refrigerator is normally delivered without door
panels. Before starting the mounting work, check that
the panel dimensions are in compliance with those given
in the Table on this page and the instructions are read
thoroughly.
When mounting the panel, proceed as follows:
See figure page 15.
A.

Open the door 90 degrees.
On new refrigerators, the decoration strips are taped
inside the door; if installed on the door, remove the
door decoration strip (2) by removing its three screws
(1), fresh food compartment door. Two screws on the
freezer compartment door.

B.

Insert the vertical edges into the grooves of the door
frame (3).

C.

Push the panel downward so that the lower horizontal
edge of the panel (4) is fitted into the bottom groove
(5).

D.

Put the decoration strip across the door so that the
gap is covered. Secure the decoration strip with the
screws removed in Step A (1).

PANEL DIMENSIONS

MAX. THICKNESS 5/32" (4 mm)

REFR.MODEL

HEIGHT

WIDTH

RM 1272

MAX.

MIN.

MAX.

MIN.

Frozen Food

55-3/16

55-1/8

10-9/16

10-7/16

Compartment

(1402)

(1400)

(268)

(265)

Fresh Food

55-3/16

55-1/8

20-3/4

20-5/8

Compartment

(1402)

(1400)

(527)

(524)

SPARE PARTS

The following list is a list of commonly used parts which
should be available, if required, from your Dometic
Service Center.

Part No.

Description

  17 37 58-03/8

Heater, 210W, 120V

  95 50 01-67/2

Burner pipe, cpl.

200 74 19-33/2

Jet, No. 76

293 11 32-01/9

Spark ignition device

293 14 95-01/0

Electrode

293 18 26-02/4

Thermocouple

293 21 06-01/2

Lamp cover

293 25 75-02/6

Doorshelf, lower

293 25 76-02/4

Doorshelf, 4 pieces

293 26 21-02/8

Box vegetable-, 2 pieces (crisper)

293 26 21-03/6

Box vegetable-, (meat locker)

293 26 58-01/2

Bottle holder, 4 pieces

293 26 67-05/4

Baffle

Contact an authorized service center for
parts and repairs as needed.

14

Содержание RM 1272

















Отзывы: