6
LA-03 MODEL AWNING INSTALLATION INSTRUCTIONS
c.
Install a recessed AC outlet box (FS type outside water
tight, not supplied). The electrical outlet box cover must
be flush with the side wall of the coach. It must be a
minimum of 1-1/8" away from the RH end plate, but not
more than 1-1/4" maximum. It must be 3-1/8 " down from
the top of the awning case. See FIG. 9 & 9A.
Note: This placing will allow the 3308645.XXX Decorative End
Cap Kit to be installed over the outlet box.
d.
Route a 14 AWG 3 conductor w/ground copper Romex
wire (not supplied) between the outlet box on the awning
control box and the outlet box next to the right hand end
of the awning. Secure at both outlet boxes using Romex
connectors (not supplied), leaving 8 inches of wire
extended. See FIG. 9.
e.
Drill a 0.750” diameter hole in the center of the outside
outlet box cover and install the water tight pigtail wire
harness female receptacle plug. Connect the 4 wires
from the pigtail harness to the 3 conductor w/ground
Romex wires in the outlet box with wire nuts (Black -
Black, White - White, Red - Red, & Green, Green w/
yellow stripe - bare copper or Ground) and tape the
connections.
FIG. 9
AC Breaker
Box *
Control Box &
Junction Box
Outdoor Rated Outlet Box
Recessed Into Wall *
AC Supply
Line *
Outlet Box With
GFI Receptacle *
14 AWG 3 Conductor
W/Ground Romex *
Awning Motor
Lead With 6”
Drip Loop
Awning
Control Box
6’ Power Cord
Wind Sensor
Wind Sensor
Cable*
Align Key On
Motor Lead
With Slot On
Receptacle
Battery *
Brown Wire *
- 12VDC
Pink Wire *
+12VDC
Remote
Switch
Ignition
Switch*
Yellow
Brown
Green
Wires *
* Designates
Installer Supplied
f.
Place the cover with the connector plug and gasket on
the junction box and tighten the screws.
g.
The awning motor cable is to be connected to the cover
receptacle on the junction box cover. Be sure to form a
3/16"
1/8"
3"
Awning
Case
Use Mounting Bracket as
Template, Mark and Drill 3
Pilot Holes, Fill Holes with
Silicon Sealant
FIG. 9A
Outlet Box
