Dometic 9600011575, Руководство по установке

Страница: 10 / 220

EN
Installation RTX1000/2000, SPX1200T
10
6.5 Attaching the seal for the cab roof
A
➤
Glue the sealing strip to the cab roof (fig.
9
A).
Follow the contour of the roof hatch opening. The join between the ends of
the seal shall be at the short side.
➤
Apply a flexible, non-hardening butyl sealant (e.g. SikaLastomer-710) to the
join between the ends of the sealing strip and to the top edge of the sealing
strip (fig.
9
B).
6.6 Fitting the unit in the roof hatch
!
➤
Place the parking cooler centrally and facing forwards in the roof hatch
opening (fig.
0
).
I
A
➤
Fix the parking cooler in place as illustrated (fig.
a
).
6.7 Routing the electrical power supply leads
D
!
NOTICE!
Ensure that the surface where the seal between the unit and the cab roof is to
be glued is clean (free of dust, oil, etc.).
CAUTION! Risk of injury
Only install the unit in support of e. g. second person, crane, working platform.
The work safety must be guaranteed at all times.
NOTE
Once the unit is in position on the vehicle roof, the seal should make contact all
the way round. Only then can a reliable seal be achieved.
NOTICE!
Do not exceed the specified tightening torque under any circumstances. That
is the only way to ensure that the threaded plugs are not pulled out.
DANGER!
For EX/III and FL vehicles (according to ADR guideline), a battery master switch
must be installed.
WARNING!
•
The electrical connections may only be made by competent technical staff
with the appropriate specialist knowledge.
•
Before carrying out any work on electrically operated components, make
sure that they are disconnected from the power supply.
0$157;63;7,VERRN6HLWH'RQQHUVWDJ0lU]