Dometic 4443000399, Руководство по установке

Страница: 31 / 126

29
EN
Frigo DC Installing the control unit
➤
Mark the position of the drill holes under the cover (position see fig.
7
,
page 6 and fig.
8
, page 6). The distance to the wall of the loading area is to
be at least 20 mm.
➤
Drill four holes into the insulation with Ø 4.5 mm (fig.
7
, page 6 and fig.
8
,
page 6).
➤
Attach the evaporator with an appropriate fastening material (fig.
9
,
page 7).
8 Installing the control unit
The control unit can be installed with the fastening frame in a suitable cutout in
the dashboard or on a suitable place in the vehicle cab using the supplied con-
sole. For the dimensions of the control panel, see fig.
0
, page 7.
8.1 Installing in the dashboard
Proceed as illustrated (fig.
a
, page 8):
➤
Determine a suitable installation position for the control unit in the vehicle
cab.
➤
Make a rectangular cutout of 71 mm x 29 mm.
➤
Attach the control unit with the sealing and the fastening frame.
➤
Connect the control unit cable set.
➤
Route the cable in the vehicle (see circuit diagram (supplementary sheet) and
schematic connection diagrams fig.
f
, page 11 and fig.
g
, page 11).
8.2 Installing the console
Proceed as illustrated (fig.
b
, page 8):
➤
Determine a suitable installation position for the console in the vehicle cab.
➤
Attach both holders with the 4 black 3.9 x 9.5 self-tapping screws.
➤
Attach the control unit with the sealing and the frame.
➤
Connect the cable set.
➤
Attach the console to the holders with the 4 M4 x 16 bolts and M4 washers.
Frigo_DC-I-West.book Seite 29 Montag, 19. November 2018 12:09 12