Digital Video Recorder User Manual
7
2.2 Connect the cameras and monitors
2.2.1 Connect the camera signal to the DVR video input via BNC cable, and then connect the DVR video
output to the monitor via VGA. If the camera supports PTZ control, connect the camera cable to the DVR video
input via RS-485 interface.
2.2.2 System connection diagram, for example 8CH DVR connection as follows:
.
Picture 2.1 System connection diagram
2.3 Connect the Power
Please use the power adapt to the DVR. After connection, please checks to make sure that the audio and
video input/output interface are well connected.
Chapter3-Basic Operation Instructions
3.1 Power On/Off your DVR
Notice
: 1.Before you power on the unit, please make sure all the connection is good.
2. Proper startup and shutdown procedures are crucial to expanding the life of your DVR.
3. Suggest using UPS to protect the power supply under allowable conditions.
3.1.1 Power on your DVR
Plug the power supply and turn on the power supply switch. Power supply indicator light shining indicates
turning on the DVR. After startup you will hear a beep. The default setting of video output is multiple window
output modes. If the startup time is within the video setting time, the timing video recording function will start up
automatically. Then the video indicator light of corresponding channel is shinning and the DVR is working
normally.
