Dolphin dolksf1kb, Руководство пользователя

Страница: 5 / 12

•
It flashes on Standby. The Yellow LED also indicates the system’s status in
synchronization with the tones.
• Red/Green
• It lights up Green for Output 1 activation; and Red for Output 2 activation.
KEYPAD TONES AND THE LED SIGNALS
STATUS TONES LED SIGNALS
1. In programming mode Solid Yellow
2. Successful key entry 1 Beep 1 Flash
3. Successful code entry 2 Beeps 2 Flashes
4. Unsuccessful code entry 5 Beeps 5 Flashes
5. Power-up delay Continuous Beeps Continuous Flashes
6. Output relay activation 1-second Beep
7. Standby 1 flash every second
8. System refreshing Quick flashes for 2.5 minutes
9. Pin already stored in system Long Beep
THE JUMPER FOR BACKLIT OPTIONS
Located on the upper-left corner; the two options are for full lights or auto lights.
1. Full backlit – The keypad constantly illuminates.
2. Auto backlit – The keypad only illuminates during use.
DIRECT ACCESS PROGRAMMING WITH CODE: 8080
By pressing the egress button and entering code: 8080 during the 1-minute booting time, the
keypad will bypass the Master Code to enter Programming Mode. Take these following steps to
use DAP:
1. Switch the power to off for about 1 minute to ensure total discharge
2. Switch the power to on. The system will have a 1-minute boot-up period
3. Press the egress button once to enable the DAP function
4. Enter: 8080, *, *. The Master Code will be erased and the keypad will enter Programming
Mode.
RESET TO FACTORY SETTINGS WITH CODE: 9999
While in programming mode, enter: 9999, # to reset the keypad to default factory settings.
•
Allow up to 2.5 minutes for the keypad to reset. The yellow LED will indicate when the keypad
has finished resetting
•
The current Master Code will not reset
ACCESS LOCK
Access Lock is an optional feature of the DOLKSF1KB. An authorization code can be set-up to
control access. The authorization code will lock all access to all users until unlocked. While
Access Lock is activated, the red LED will remain on.