Dolmar AL-3630, Инструкция по эксплуатации

Страница: 12 / 96

12
012856
OPTIONAL ACCESSORIES
CAUTION:
• These accessories or attachments are recommended
for use with your Dolmar tool specified in this manual.
The use of any other accessories or attachments might
present a risk of injury to persons. Only use accessory
or attachment for its stated purpose.
If you need any assistance for more details regarding
these accessories, ask your local Dolmar service center.
• Dolmar genuine battery and charger
• Battery converter AA-3618CL
NOTE:
• Some items in the list may be included in the tool
package as standard accessories. They may differ
from country to country.
Noise
ENG905-1
The typical A-weighted noise level determined according
to EN786:
Sound pressure level (L
pA
): 82 dB (A)
Sound power level (L
WA
): 90 dB (A)
Uncertainty (K): 0.4 dB (A)
Wear ear protection
Vibration
ENG904-1
The vibration emission value determined according to
EN786:
Vibration emission (a
h
): 5.5 m/s
2
Uncertainty (K): 1.5 m/s
2
ENG901-1
• The declared vibration emission value has been
measured in accordance with the standard test method
and may be used for comparing one tool with another.
• The declared vibration emission value may also be
used in a preliminary assessment of exposure.
Malfunction status Cause Action
Motor does not run.
Battery cartridge is not installed. Install the battery cartridge.
Battery problem (under voltage).
Recharge the battery. If recharging is not
effective, replace battery.
The drive system does not work
correctly. Ask your local authorized service center
for repair.
Motor stops running after a little
use.
Rotation is in reverse.
Change the direction of rotation with the
reversing switch.
Battery’s charge level is low.
Recharge the battery. If recharging is not
effective, replace battery.
Overheating.
Stop using of tool to allow it to cool
down.
It does not reach maximum RPM.
Battery is installed improperly.
Install the battery cartridge as described
in this manual.
Battery power is dropping.
Recharge the battery. If recharging is not
effective, replace battery.
The drive system does not work
correctly. Ask your local authorized service center
for repair.
The nylon cutting cord does not
feed. The cord is used up or tangled in the
spool.
Rewind the cord.
The nylon cutting cord is not cut off
at the correct length.
The cord cutter on the protector is
damaged or missing. Ask your local authorized service center
for repair.
The cord extends past the protector. Rewind the cord.
Cutting head does not rotate:
Stop the tool immediately!
Foreign object such as branch is jammed
between the guard and the nylon cutting
head.
Remove the foreign object.
The drive system does not work
correctly. Ask your local authorized service center
for repair.
Abnormal vibration:
Stop the tool immediately!
One nylon cord has been broken and the
head got unbalanced.
Bump the nylon cutting head against the
ground while it is rotating to cause the
cord to feed.
The drive system does not work
correctly. Ask your local authorized service center
for repair.
Cutting head and motor cannot
stop:
Remove the battery immediately!
Electric or electronic malfunction.
Remove the battery and ask your local
authorized service center for repair.