The Formwork Experts
16
999771002 - 08/2008 Ü
User information Doka forming wagon T
Dimensioning of the ballast
As well as by the weights of the components
involved and by the live loads, the dimensioning of
the ballast will also be influenced by the following
factors:
●
position of Pressure prop T
●
position of formwork unit as a whole
●
position of ballast
●
repositioning operation (no Pressure prop T)
Position of Pressure prop T
The Pressure prop T (A) can be attached to several
possible positions on the double jib. This permits
additional project-specific optimisation.
a1 ... 50.0 cm
a2 ... 120 cm (standard ex-factory setting)
a3 ... 257.0 cm (for special applications)
Note:
Where distance a1=50 cm and a3=257 cm, the
standard Spindle strut GS T6 95/140cm (C) cannot
be used. On-site fixing is needed in this case.
Position of formwork unit as a
whole
The position of the suspension beam, together with
the platform and the formwork, can be continu-
ously adjusted within the range indicated b, as
required.
The position set here will also have an influence on
the size of the ballast (B) (see diagram on next
page).
b ... 220.0 to 375.0 cm
☞
Important note:
The weight calculated for the ballast must
be sufficient to permit all the forces to be
sustained with an adequate margin of
safety!
A Pressure prop T
B Ballast
C Spindle strut GS T6 95/140cm
9730-302-01a
a1
a2
a3
A
C
B
9730-303-01
b
B
