Dodge 2015 Charger, Руководство по эксплуатации

Страница: 248 / 712

The TPMS consists of the following compo-
nents:
•
Receiver module,
•
Four TPM sensors,
•
Various TPMS messages, which display in
the Driver Information Display (DID), and
•
TPM Telltale Light
Tire Pressure Monitoring Low Pressure
Warnings
The “TPM Telltale Light” will illuminate
in the instrument cluster and a chime
will sound when tire pressure is low in
one or more of the four active road
tires. In addition, the DID will display a “LOW
TIRE” message and a graphic showing the
pressure values of each tire with the low tire
pressure values shown in a different color. An
"
Inflate Tire to XX
"
message will also be dis-
played in the DID display.
Should this occur, you should stop as soon as
possible and inflate all of the tires with a low
pressure condition (those shown in a different
color in the DID graphic) to the vehicle’s recom-
mended cold placard pressure inflation value as
shown in the
" Inflate Tire to XX " message. Once
the system receives the updated tire pressures,
the system will automatically update, the
graphic display in the DID will return the pres-
sure values shown to their original color, and
the “TPM Telltale Light” will turn off. The vehicle
may need to be driven for up to 20 minutes
above 15 mph (24 km/h) in order for the TPMS
to receive this information.
Service TPMS Warning
If a system fault is detected, the “TPM Telltale
Light” will flash on and off for 75 seconds and
then remain on solid. The system fault will also
sound a chime. In addition, the DID will display
a
" SERVICE TPM SYSTEM " message for a
minimum of five seconds and then display
dashes (- -) in place of the pressure value to
indicate which sensor is not being received.
If the ignition switch is cycled, this sequence will
repeat, providing the system fault still exists. If
the system fault no longer exists, the “TPM
Telltale Light” will no longer flash, and the
" SERVICE TPM SYSTEM " message will no
longer display, and a pressure value will display
in place of the dashes. A system fault can occur
due to any of the following:
1. Signal interference due to electronic devices
or driving next to facilities emitting the same
radio frequencies as the TPM sensors.
2. Installing aftermarket window tinting that
contains materials that may block radio
wave signals.
3. Accumulation of snow or ice around the
wheels or wheel housings.
4. Using tire chains on the vehicle.
5. Using wheels/tires not equipped with TPM
sensors.
The DID will also display a " SERVICE TPM
SYSTEM " message for a minimum of five sec-
onds when a system fault related to an incorrect
sensor location fault is detected. In this case,
the
" SERVICE TPM SYSTEM " message is then
followed with a graphic display with pressure
values still shown. This indicates that the pres-
sure values are still being received from the
TPM sensors but they may not be located in the
correct vehicle position. The system still needs
245